Placing Originals
93
2
Placing Originals
This section describes the procedure for placing originals on the exposure glass
and in the ADF.
Important
❒ Do not place originals before any correction fluid and toner has completely
dried. Doing so may make marks on the exposure glass that will appear on
copies.
❒ The original in the ADF takes precedence over the original on the exposure
glass if you place originals both in the ADF and on the exposure glass.
Note
❒ Because colors made by marker or highlighter pen on originals are difficult to
reproduce, they might not appear on copies, or might appear as different col-
ors.
Placing originals on the exposure glass
The exposure glass enables you to scan and send documents that cannot be fed
into the ADF.
Important
❒ Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or
be damaged.
A Lift the exposure glass cover or ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might
be damaged.
B Place the original face down on the exposure glass. The original should be
aligned to the rear left corner.
C Lower the exposure glass cover or ADF.
BAA050S
To Next Page
Loading...
Need help?
General
