Scanning Using the Control Panel
151
5
• When the power is turned off.
• When the machine's default for the same setting is changed.
Reference
For details about [Density], see p.206 “Scanner Settings”.
For details about [Auto Clear], see p.231 “Administrator Settings”.
Specifying resolution
This section describes how to specify the scan resolution for the current job.
There are six resolution settings. The higher the resolution, the higher the quality
but greater the file size.
A Press the {Image Quality} key.
B Press the {Image Quality} key or {U}{T} keys to select the desired resolution,
and then press the {OK} key.
Note
❒ Press the {} key or {Clear/Stop} key to discard the current change and re-
turn to the initial screen.
❒ You can change the machine's default [Resolution] setting to always scan
with a specific resolution level.
❒ Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [Auto Clear]
while the initial screen is displayed.
•When the {Clear/Stop} key is pressed while the initial screen is dis-
played.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Reference
For details about [Resolution], see p.206 “Scanner Settings”.
For details about [Auto Clear], see p.231 “Administrator Settings”.
BPC023S
To Next Page
Loading...
