Sending a Fax
179
6
Specifying the resolution
This section describes how to specify the scan resolution for the current job.
There are three resolution settings:
❖ Standard
Select this when the original is a printed or typewritten document with nor-
mal-sized characters.
❖ Fine
Select this when the original is a document with small print.
❖ Photo
Select this when the original contains images such as photographs or shaded
drawings.
A Press the {Image Quality} key.
B Press the {Image Quality} key or {U}{T} keys to select the desired resolution
setting, and then press the {OK} key.
Note
❒ Press the {} key or {Clear/Stop} key to discard the current change and re-
turn to the initial screen.
❒ You can change the machine's default [Resolution] setting to always scan
with a specific resolution level.
❒ Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [Auto Clear]
while the initial screen is displayed.
• When the
{
Clear/Stop
}
key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Reference
For details about [Resolution], see p.209 “Fax Transmission Settings”.
For details about [Auto Clear], see p.231 “Administrator Settings”.
BPC023S
To Next Page
Loading...
Need help?
General
