Moving the Machine
319
10
Moving the Machine
This section provides cautions that you must follow when moving the machine
both short and long distances.
CAUTION:
Repack the machine in its original packing materials when moving it a long dis-
tance.
Important
❒ Be sure to disconnect all cables from the machine before transporting it.
❒ The machine is a precision piece of machinery. Be sure to handle it carefully
when moving it.
❒ Make sure to move the machine horizontally. Take extra caution when carry-
ing the machine up or down stairs.
❒ If tray 2 is installed, remove it from the machine, and move them separately.
❒ Do not hold onto the tray area when lifting the machine.
Moving over a Short Distance
Important
❒ Do not remove the print cartridges when moving the machine.
A Be sure to check the following points:
• The power switch is turned off.
• The power cord is unplugged from the wall outlet.
• All other cables are unplugged from the machine.
B If tray 2 is installed, remove it.
C Return the scanning unit inside the machine to its original position using
[Scanner Carriage] under [Machine Settings].
• The machine weighs approximately 30.0 kg (66.2 lb.). When moving the
machine, use the inset grips on both sides, and lift slowly in pairs. The ma-
chine will break or cause injury if dropped.
• Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, you should take care that the power cord will
not be damaged under the machine.
• When you disconnect the power plug from the wall outlet, always pull the
plug (not the cable).
• When moving the machine after use, do not take out any of the toners, nor
the waste toner bottle to prevent toner spill inside the machine.
To Next Page
Loading...
Need help?
General
