Placing Originals
91
2
Placing Originals
This section describes the types of originals you can set and how to place them.
About Originals
This section describes the types of originals that can be placed and which parts
of the original are unscannable.
Recommended size of originals
This section describes the recommended size of the original.
❖ Exposure glass
Up to 216 mm (8.5 ") in width, up to 297 mm (11.7 ") in length
❖ ADF
• Paper size: 140 to 216 mm (5
1
/
2
" to 8
1
/
2
") in width, 140 to 356 mm (5
1
/
2
" to
14 ") in length
• Paper weight: 64 to 90 g/m
2
(17 to 24 lb.)
Note
❒ Only 1 sheet of an original can be placed on the exposure glass at a time.
❒ Up to 35 sheets of an original can be placed in the ADF at once (when using
paper weighing 80 g/m
2
, 20 lb.).
Types of originals not supported by the Auto Document Feeder
If placed in the ADF, the following types of original might be damaged or be-
come jammed, or result in gray or black lines appearing on prints:
• Originals larger or heavier than recommended
• Stapled or clipped originals
• Perforated or torn originals
• Curled, folded, or creased originals
• Pasted originals
• Originals with any kind of coating, such as thermal fax paper, art paper, alu-
minum foil, carbon paper, or conductive paper
• Originals with perforated lines
• Originals with indexes, tags, or other projecting parts
• Sticky originals such as translucent paper
• Thin, highly flexible originals
• Thick originals such as postcards
• Bound originals such as books
To Next Page
Loading...
Need help?
General
