Ricoh Aficio SP C232SF - Specifying the Scan Settings; Adjusting Image Density

Using the Fax Function
178
6
Specifying the Scan Settings
This section describes how to specify image density and resolution for the cur-
rent scan job.
Adjusting image density
This section describes how to adjust image density for the current job.
There are three image density levels. The darker the density level, the darker the
printout.
A Press the {Density} key.
B Press the {Density} key or {U}{T} keys to select the desired density level,
and then press the {OK} key.
Note
❒ Press the {} key or {Clear/Stop} key to discard the current change and re-
turn to the initial screen.
❒ You can change the machine's default [Density] setting to always scan with
a specific density level.
❒ Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [Auto Clear]
while the initial screen is displayed.
•When the {Clear/Stop} key is pressed while the initial screen is dis-
played.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Reference
For details about [Density], see p.209 “Fax Transmission Settings”.
For details about [Auto Clear], see p.231 “Administrator Settings”.
BPC022S