Entering Characters
95
2
Entering Characters
This section describes how to enter characters using the control panel when con-
figuring the machine's settings.
There are three modes for entering characters, depending on the type of setting
you are configuring:
• Value input mode for entering numerical values.
• Fax number input mode for entering fax numbers.
• Text input mode for entering names.
Value Input Mode
Value input mode becomes active when configuring settings such as paper size
or copy zoom ratio. In this mode, use the keys as follows:
• To enter a digit
Press a number key. Press the number keys successively to enter a multi-digit
number.
• To increase or decrease the current value in units
Press the {U}{T} keys. The unit of increments depends on the setting you are
configuring.
Note
❒ If a digit is entered more than three seconds after the last input, the entered
digit replaces the current value.
❒ When the maximum number of digits has already been entered, the next in-
put digit replaces the current value.
❒ If the current value is too large or too small for the current setting, it will not
be accepted. In this case, pressing the {U} or {T} key changes the value to the
minimum or maximum value for the current setting, respectively.
To Next Page
Loading...
Need help?
General
