Registering Scan Destinations
143
5
Reference
To test sending files to a Scan to FTP or Scan to Folder destination, see
p.145 “Scanning Using the Control Panel”.
For details about creating backup files, see p.265 “Backing Up the Ma-
chine's Settings”.
For details about SMTP and DNS settings, see p.259 “Configuring the DNS
Settings” and p.262 “Configuring the SMTP Settings”.
For details about the time zone setting, see p.262 “Configuring the SMTP
Settings”.
For details about using Web Image Monitor, see p.241 “Using Web Image
Monitor”.
Modifying Scan Destinations
This section describes how to modify the information of registered destinations.
A Start the Web browser, and access the machine by entering its IP address.
B Click [Scan Destination].
C Select the entry to modify, and then click [Edit].
D Modify settings as necessary.
E Enter the administrator password if required.
F Click [Submit].
G Close the Web browser.
Note
❒ You can unassign a Quick Dial entry from a One-touch button from the
[One Touch Button] page. To do this, select the desired entry, click [Exclude],
and then click [Exclude] again on a confirmation page.
Reference
For details about using Web Image Monitor, see p.241 “Using Web Image
Monitor”.
Deleting Scan Destinations
This section describes how to delete registered destinations.
A Start the Web browser, and access the machine by entering its IP address.
B Click [Scan Destination].
C Select the entry to delete, and then click [Delete].
To Next Page
Loading...
Need help?
General
