Scanning Using the Control Panel
147
5
Reference
To place the original, see p.91 “Placing Originals”.
To configure advanced scan settings, see p.148 “Specifying the Scan Set-
tings”.
For details about specifying the scan destination, see p.147 “Specifying the
scan destination”.
For details about [Multi Page in A Document] or [Limitless Scan], see p.206
“Scanner Settings”.
For details about how to remove the paper jammed in the ADF, see p.278
“Removing Scanning Jams”.
Specifying the scan destination
This section describes how to specify a destination using the following keys:
•One Touch buttons
Use these to specify destinations registered as Quick Dial entries.
• {Pause/Redial} key
Press this to specify the last used destination as the destination for the current
job.
❖ Using the One Touch buttons
Press the One Touch button to which the desired Quick Dial entry is regis-
tered.
Press the {Shift} key to toggle the One Touch buttons between Quick Dial en-
tries Nos.1 to 10 and Nos. 11 to 20.
BPC027S
To Next Page
Loading...
