Guide to the Machine
6
1
Using Manuals
Be sure to read this section before any other part of this manual.
• This manual uses procedures based on Windows XP as an example, unless
otherwise specified. Procedures and screens might vary depending on the op-
erating system you are using.
Installing Manuals on Your Computer
The “Manuals” CD-ROM provided with the machine contains manuals in
HTML format and PDF. Follow the instructions below to install it.
Important
❒ System requirements for viewing the HTML manual:
• 800 × 600 pixel display resolution or greater
❒ Applications for viewing the HTML manual:
•Microsoft
®
Internet Explorer 4.01 Service Pack 2 or higher
• Netscape 6.2 or higher
❒ Applications for viewing the PDF manuals:
• Adobe Acrobat Reader or Adobe Reader
A Quit all applications currently running.
B Insert the “Manuals” CD-ROM into the CD-ROM drive.
If you are using a computer running a Macintosh operating system, open
“Manuals.htm” from the CD-ROM root directory.
C Select a language for the interface and a product, and then click [OK].
D Click [Install manuals].
E Follow the instructions on the screen to complete the installation.
F Click [Finish] when the installation is completed.
G Click [Exit].
Note
❒ If you are using a computer running a Windows operating system, the CD-
ROM opens automatically. However, AutoRun may not work under cer-
tain operating system settings. If this is the case, launch “setup.exe” from
the CD-ROM root directory.
To Next Page
Loading...
Need help?
General
