Configuring the Machine Using the Control Panel
220
7
❖ I/O Timeout
•USB
Specifies how many seconds the machine waits for print data, if the data is
interrupted while it is being sent from the computer via USB. If the ma-
chine does not receive any more data within the time specified here, the
machine only prints the data it has received. If printing is frequently inter-
rupted by data from other ports, increase the timeout period.
Default: 60 seconds
• 15 sec
• 60 sec
• 300 sec
• Network
Specifies how many seconds the machine waits for print data, if the data is
interrupted while it is being sent from the computer via network. If the ma-
chine does not receive any more data within the time specified here, the
machine only prints the data it has received. If printing is frequently inter-
rupted by data from other ports, increase the timeout period.
Default: 60 seconds
• 15 sec
• 60 sec
• 300 sec
•Locked Print
Specifies how many seconds the machine holds a new Locked Print file,
when the machine cannot store any more Locked Print files. Within this
time, you can print or delete the new Locked Print file. You can also print
or delete an existing Locked Print file so that the new Locked Print file can
be stored in the machine.
Default: 60 seconds
• 0 to 300 seconds, in increments of 1 second
• Restrict User
Specifies how many seconds a user stays authenticated after paper is out-
put when copying with the exposure glass. Note that authentication auto-
matically expires immediately after copying using the ADF, sending a fax,
or scanning using the control panel.
This setting appears only when the user restriction function is enabled via
Web Image Monitor.
Default: 30 seconds
• 5 to 60 seconds, in increments of 1 second
To Next Page
Loading...
Need help?
General
