Troubleshooting
284
9
There is considerable delay be-
tween the print start command
and actual printing.
• Processing time depends on data volume. High volume
data, such as graphics-heavy documents, take longer to
process.
• If "Processing" is displayed on the screen, the machine is
receiving data. Wait for a while.
• To speed up printing, reduce the printing resolution us-
ing the printer driver. For details, see the printer driver
Help.
• The machine is calibrating color. Wait for a while.
Prints fall behind the machine
when they are output.
Raise the appropriate stop fence (forward fence for A4/Let-
ter, rear fence for Legal size prints). See p.21 “Exterior: Rear
View”.
Prints do not stack properly. • Paper is damp. Use paper that has been stored properly.
See p.64 “Paper and Other Media”.
• Select [Mode2] or [Mode3] in [High Humidity Mode] under
[Machine Settings]. Note that if you select [Mode2] or
[Mode3], the first print takes longer than subsequent
prints to complete.
• Raise the appropriate stop fence (forward fence for
A4/Letter, rear fence for Legal size prints). See p.21 “Ex-
terior: Rear View”.
The whole printout is blurred. • Paper is damp. Use paper that has been stored properly.
See p.64 “Paper and Other Media”.
• Select [Mode1], [Mode2] or [Mode3] in [High Humidity Mode]
under [Machine Settings]. Note that if you select [Mode2] or
[Mode3], the first print takes longer than subsequent
prints to complete.
• If you enable [Toner Saver Mode] under [Machine Settings],
printing is generally less dense.
• Toner is almost depleted. If “Near End X Toner” (“X" in-
dicates the toner color) appears on the screen, replace the
indicated print cartridge.
• Condensation may have collected. If rapid change in
temperature or humidity occurs, use this machine only
after it has acclimatized.
The toner is powdery and comes
away from the paper, or the
printed image has a matt appear-
ance.
Check if the fusing unit lever is lowered or the grey knobs
are positioned as in the image below.
Problem Solution
ASH129S
To Next Page
Loading...
