1414
Using the Scanner Function
Press the [B&W Start] key or the
[Color Start] key.
Depending on the machine's settings, you
may be prompted to place another original
on the exposure glass. In this case,
proceed to the next step.
If you have more originals to scan, place the next original on the
exposure glass, and then press [1]. Repeat this step until all
originals are scanned.
When all originals have been scanned, press [2] to start sending
the scanned file.
• To cancel scanning, press the [Scanner] key, and then press the [Clear/Stop] key. The scan files
are discarded.
• If paper is jammed in the ADF, the scan file is discarded. In this case, scan the entire originals
again. To remove paper jams in the ADF, see "Removing from the ADF" page 29.
• You can also specify a destination using the One Touch buttons or [Pause/Redial] key. For
details, see "Using the Scanner Function", User Guide.
• For information about originals, see "Getting Started", User Guide.
To Next Page
Loading...
Need help?
General
