Bit Switches – 1
D0CK 58 SM
1: Direct sending on Setting this switch to "0" masks the direct sending function on the
operation panel so direct sending with ScanRouter cannot be
selected.
3 Action when the external
handset goes off-hook
0: Manual tx and rx
operation
1: Memory tx and rx
operation (the display
remains the same)
0: Manual tx is possible while the external handset is off-hook.
However, manual tx during handset off-hook may not be sent to a
correct direction. Manual tx is not possible.
1: The display stays in standby mode even when the external
handset is used, so that other people can use the machine for
memory tx operation. Note that manual tx and rx are not possible
with this setting.
4-
7
Not used Do not change these settings.
System Switch 0F (SP No. 1-101-016)
No Function Comments
0
to
7
Country/area code for
functional settings (Hex)
This country/area code determines the factory settings of bit
switches and RAM addresses. However, it has no effect on the
NCU parameter settings and communication parameter RAM
addresses.
Cross reference
NCU country code:
SP No. 2-103-001 for G3-1
SP No. 2-104-001 for G3-2
SP No. 2-105-001 for G3-3
00: France 12: Asia
01:
Germany
13: Japan
02: UK 14: Hong
Kong
03: Italy 15: South
Africa
04: Austria 16: Australia
05: Belgium 17: New
Zealand
06:
Denmark
18: Singapore
07: Finland 19: Malaysia
08: Ireland 1A: China
09: Norway 1B: Taiwan
0A:
Sweden
1C: Korea
0B: Switz. 1D: Brazil
0C:
Portugal
20: Turkey
0D: Holland 21: Greece
To Next Page
Loading...
