Bit Switches – 1
SM 59 D0CK
0E: Spain 22: Hungary
0F: Israel 23: Czech
10: --- 24: Poland
11: USA
System Switch 10 (SP No. 1-101-017)
No Function Comments
0-7 Threshold memory level for parallel memory transmission Threshold = N x 128 KB + 256 KB
N can be between 00 - FF(H)
Default setting: 02(H) = 512 KB
System Switch 11 (SP No. 1-101-018)
No Function Comments
0 TTI printing position
0: Superimposed on the page
data
1: Printed before the data
leading edge
Change this bit to 1 if the TTI overprints information that the
customer considers to be important (G3 transmissions).
NOTE: If "1" is selected, it is possible that sent data is
printed on two sheets of paper.
1-
2
Not used Do not change these settings.
3 TTI used for broadcasting
0: The TTIs selected for each
Quick/Speed dial are used
1: The same TTI is used for all
destinations
1: The TTI (TTI_1 or TTI_2) which is selected for all
destinations during broadcasting.
4-
7
Not used Do not change these settings.
System Switch 12 (SP No. 1-101-019)
No Function Comments
0-
7
TTI printing
position in the
main scan
direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI from the left edge
of the paper. If the TTI is moved too far to the right, it may overwrite the file
number which is on the top right of the page. On an A4 page, if the TTI is
moved over by more than 50 mm, it may overwrite the page number.
To Next Page
Loading...
