Ricoh IM C400F - Page 1535

Bit Switches – 1
D0CK 60 SM
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 (SP No. 1-101-022)
No Function Comments
0 Not used Do not change the settings.
1 Going into the Energy Saver mode
automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver mode
quickly, because the +5V power supply is active even in
the Energy Saver mode. The LED of the operation switch
is flashing instead of entering Energy Saver mode.
Use this setting if an external telephone has to be used
when the machine is in the Energy Saver mode.
2-
3
Not used Do not change these settings.
4-
5
Interval for preventing the machine
from entering Energy Saver mode if
there is a pending transmission file.
If there is a file waiting for transmission, the machine
does not go to Energy Saver mode during the selected
period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver
mode.
Bit 5 Bit 4 Setting
0 0 1 min
0 1 30 min
1 0 1 hour
1 1 24 hours
6-
7
Not used Do not change the settings.
System Switch 16 (SP No. 1-101-023)
No Function Comments
0 Parallel
Broadcasting
0: Disabled
1: Enabled
1: The machine sends messages simultaneously using all available ports
during broadcasting.
NOTE: If a customer wants to keep a line available for fax reception or
other reasons, select "0" (Disable).
1-
7
Not used Do not change these settings.
System Switch 17 - Not used (do not change these settings)
System Switch 18 - Not used (do not change these settings)