Bit Switches – 1
SM 61 D0CK
System Switch 19 (SP No. 1-101-026)
No Function Comments
0-
5
Not used Do not change the settings.
6 Extended scanner
page memory after
memory option is
installed
0: Disabled
1: Enabled
0: After installing the memory expansion option, the scanner page
memory is extended to 4 MB from 2 MB.
1: If this bit is set to 1 after installing the memory expansion option,
the scanner page memory is extended to 12 MB. But the SAF
memory decreases to 18 MB.
7* Special Original mode
0: Disabled
1: Enabled
1: If the customer frequently wishes to transmit a form or letterhead
which has a colored or printed background, change this bit to "1".
"Original 1" and "Original 2" can be selected in addition to the "Text",
"Text/Photo" and "Photo" modes.
* This setting can be used for the client machine which has no FCU.
System Switch 1A (SP No. 1-101-027)
No Function Comments
0
to
7
LS RX memory capacity
threshold setting
00-FF (0-1020 Kbyte:
Hex)
Sets the value to x4KB. When the amount of available memory drops
below this setting, RX documents are printed to conserve memory.
Initial setting 0x80 (512 KB)
NOTE: If a customer wants available memory size to be larger,
decrease this threshold
System Switch 1B - Not used (do not change these settings)
System Switch 1C - Not used (do not change these settings)
System Switch 1D (SP No. 1-101-030)
No Function Comments
0 RTI/CSI/CPS code
display
0: Enable
1: Disable
0: RTI, CSI, CPS codes are displayed on the top line of the LCD panel
during communication.
1: Codes are switched off (no display)
1-
7
Not used Do not change these settings.
To Next Page
Loading...
