Bit Switches – 3
SM 79 D0CK
1: Enable (Active)
1 Remote mode switch
(FAX mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on the remote mode switch
after automatic reception with FAX mode.
2 Remote mode switch
(AUTO mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on the remote mode switch
after automatic reception with AUTO mode.
3-
7
Not used Do not change the settings.
Communication Switch 05 (SP No. 1-104-006)
No Function Comments
0-
3
Remote mode switch
number
00-09 (0-9:HEX)
Enter the number to switch between TEL/FAX modes using the
external phone.
4-
7
Not used Do not change the settings.
Communication Switch 06 - Not used (do not change the settings)
Communication Switch 07 - Not used (do not change the settings)
Communication Switch 08 - Not used (do not change the settings)
Communication Switch 09 (SP No. 1-104-009)
No Function Comments
0-
7
Minimum interval between
automatic dialing attempts
This value is the minimum time that the machine waits
before it dials the next destination.
Communication Switch 0A (SP No. 1-104-011)
No Function Comments
0 Point of resumption of memory
transmission upon redialing
0: From the error page
1: From page 1
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page, using
normal memory transmission.
1-
7
Not used Do not change these settings.
To Next Page
Loading...
