Bit Switches – 3
D0CK 80 SM
Communication Switch 0B (SP No. 1-104-012)
No Function Comments
0-
2
Not used Do not change these settings.
3 Conditions required for
Transfer Result Report
transmission
0: Always transmitted
1: Only transmitted if there was an error
4 Printout of the message
when acting as a Transfer
Station
0: Disabled, 1: Enabled
When the machine is acting as a Transfer Station, this bit
determines whether the machine prints the fax message
coming in from the Requesting Terminal.
5-
7
Not used Do not change the settings.
Communication Switch 0C - Not used (do not change the settings)
Communication Switch 0D (SP No. 1-104-014)
No Function Comments
0-
7
The available memory threshold,
below which ringing detection (and
therefore reception into memory) is
disabled
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is below
this threshold, the machine cannot receive any fax
messages.
If this setting is kept at 0, the machine will detect ringing
signals and go into receive mode even if there is no
memory available. This will result in communication
failure.
Communication Switch 0E (SP No. 1-104-015)
No Function Comments
0-
7
Minimum interval between
automatic dialing attempts
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine waits
before it dials the next destination.
Communication Switch 0F – Not used (do not change the settings.)
To Next Page
Loading...
