Paper Feed Roller
SM 13 D3GQ
2.5 PAPER FEED ROLLER
Before Replacing the Paper Feed Roller
Before replacing the paper feed roller, reset the PM counter.
1. Turn the power ON.
2. Reset the PM counter. (Refer to Chapter 3 "Replacement Procedure of the PM/Yield Parts" of
Field Service Manual)
3. Turn the power OFF.
Replacing the Paper Feed Roller
1.
Pull out the paper tray.
2. Do the following steps:
• Remove all clips on the shaft and move the roller [A] to the right side [1]. ( × 6, Bushing × 1)
• Move the shaft to the right, and pull out the shaft from the bushing at the left side.
• Lift up the shaft [2] and remove the shaft from the bushing at the right side.
• Remove the roller [B].
• Remove the paper feed roller [C]
To Next Page
Loading...
