Rohde & Schwarz R&S FSL3 - Page 1048

R&S FSL CALCulate Subsystem (Analog Demodulation, K7)
1300.2519.12 6.289 E-11
CALCulate:MARKer:FUNCtion:ADEMod Subsystem (Analog Demodulation, K7)
The CALCulate:MARKer:FUNCtion:ADEMod subsystem contains the marker functions for the option
Analog Demodulation, R&S FSL–K7.
Commands of the CALCulate:MARKer:FUNCtion:ADEMod Subsystem
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:AFRequency[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:AM[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:CARRier[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:FERRor[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:FM[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:PM[:RESult<1...6>?]
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:SINad:RESult<1...6>?
– CALCulate<1|2>:MARKer:FUNCtion:ADEMod:THD:RESult<1...6>?
CALCulate<1|2>:MARKer:FUNCtion:ADEMod:AFRequency[:RESult<1...6>?]
This command queries the audio frequency with analog demodulation. The numeric suffix
(:RESult<1...6>) indicates whether trace 1, 2, 3, 4, 5 or 6 is selected. The numeric suffixes
<1|2> are irrelevant.
Note: If several demodulation modes are activated simultaneously (e.g. with the
[SENSe:]ADEMod:FM[:TDOMain][:TYPE] command, the audio frequency of the
display mode selected with CALCulate<1|2>:FEED is returned.
Example
ADEM ON
Switches on analog demodulator
CALC:FEED 'XTIM:AM:TDOM'
Switches on AM result display.
or
CALC:FEED 'XTIM:FM:TDOM'
Switches on FM result display.
or
CALC:FEED 'XTIM:FM:AFSP'
DISP:TRAC ON
Switches on AF spectrum result display of FM and trace.
CALC:MARK:FUNC:ADEM:AFR?
Queries the audio frequency.
Characteristics
*RST value: –
SCPI: device–specific
Mode
ADEMOD