Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.640 E-11
CALCulate:MARKer<1…4>:FUNCtion Subsystem (EVDO, K84)
The CALCulate:MARKer:FUNCtion subsystem checks the marker functions in the instrument.
Commands of the CALCulate:MARKer<1…4>:FUNCtion Subsystem
– CALCulate<1|2>:MARKer<1...4>:FUNCtion:CDPower[:BTS]:RESult?
CALCulate<1|2>:MARKer<1...4>:FUNCtion:CDPower[:BTS]:RESult?
This command queries the measured and calculated values of the Code Domain Power
analysis. The channel type can be set by means of the [SENSe<1|2>:]CDPower:CTYPe
command, the slot number by means of the [SENSe<1|2>:]CDPower:SLOT command and
the code number by means of the [SENSe<1|2>:]CDPower:CODE command.
The numeric suffix at CALCulate<1|2> specifies the measurement window. The numeric suffix
at MARKer<1...4> is irrelevant for this command.
Parameter
CDPabsolute channel power absolute in dBm
CDPRelative channel power relative in dB
CERRor chip rate error in ppm
CHANnel channel number
DACtive number of active DATA channels
DMTYPe modulation type of the DATA channel type
(2=QPSK, 3=8-PSK, 4=16QAM)
EVMPeak error vector magnitude peak in %
EVMRms error vector magnitude rms in %
FERRor frequency error in Hz
FERPpm frequency error in ppm
IQIMbalance I/Q imbalance in %
IQOFfset I/Q offset in %
MACCuracy composite EVM in %
MACTive Number of active MAC channels
MTYPe modulation type of the channel type
(0=BPSK-I, 1=BPSK-Q, 2=QPSK, 3=8-PSK,
4=16QAM, 5=2BPSK)
PCDerror peak code domain error in dB
PDATa absolute power in the DATA channel type
PLENGth Length of preamble in chips
PMAC
absolute power in the MAC channel type
POFFset phase offset in rad
PPILot absolute power in the PILOT channel type
PPReamble absolute power in the PREAMBLE channel type
PTOTal total power
To Next Page
Loading...
