Analog Demodulation (Option K7) R&S FSL
1300.2519.12 4.156 E-11
Continuous Sweep
For details refer to the Continuous Sweep softkey in the in the sweep menu of the base unit.
Single Sweep
For details refer to the Single Sweep softkey in the in the sweep menu of the base unit.
Continue Sgl Sweep
For details refer to the Continue Single Sweep softkey in the in the sweep menu of the base
unit.
Meas Time
For details refer to the Meas Time softkey in the in the analog demodulation menu.
Sweep Count
For details refer to the Sweep Count softkey in the in the sweep menu of the base unit.
Softkeys of the trigger menu (Analog Demodulation mode)
The following table shows all softkeys available in the trigger menu in Analog Demodulation mode
(TRIG key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is
only available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Command
Trigger Source
Trigger Level
Trigger Polarity Pos/Neg
Trigger Offset
Trigger Source
Opens the Trigger dialog box to select the trigger mode. Additional to the trigger modes
described in section "Trigger mode overview" on page 4.31, the following trigger modes are
available:
Selected option Specified threshold
AM (Offline)
modulation depth of the AM signal
FM (Offline)
frequency of the FM signal
PM (Offline)
phase of the PM signal
RF (Offline)
level of the RF signal
To Next Page
Loading...
