Noise Figure Measurements Option (K30) R&S FSL
1300.2519.12 4.266 E-11
Softkeys of the trace menu (Noise mode)
Using the trace memory facility, you can save graphical display results (max. 3 trace sets) for
comparison with subsequent measurements. This facility is recommended in order to compare and to
document the effects of small changes on the DUT.
The following table shows all softkeys available in the trace menu in Noise mode (TRACE key). It is
p
ossible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Display Graph/List
ASCII File Export
Decim Sep
More
Data –> Mem1
Data –> Mem2
Data –> Mem3
Data On/Off
Mem1 On/Off
Mem2 On/Off
Mem3 On/Off
Display Graph/List
For details refer to the Display List/Graph softkey in the noise figure measurements menu.
ASCII File Export
For details refer to the ASCII File Export softkey in the trace menu of the base unit.
Decim Sep
For details refer to the Decim Sep softkey in the trace menu of the base unit.
To Next Page
Loading...
