Rohde & Schwarz R&S FSL3 - Page 871

CALCulate Subsystem R&S FSL
1300.2519.12 6.112 E-11
CALCulate:STATistics Subsystem
The CALCulate:STATistics subsystem controls the statistical measurement functions in the instrument.
Commands of the CALCulate:STATistics Subsystem
– CALCulate:STATistics:APD[:STATe]
– CALCulate:STATistics:CCDF[:STATe]
– CALCulate:STATistics:NSAMples
– CALCulate:STATistics:PRESet
– CALCulate:STATistics:RESult<1...6>?
– CALCulate:STATistics:SCALe:AUTO
– CALCulate:STATistics:SCALe:X:RANGe
– CALCulate:STATistics:SCALe:X:RLEVel
– CALCulate:STATistics:SCALe:Y:LOWer
– CALCulate:STATistics:SCALe:Y:UNIT
– CALCulate:STATistics:SCALe:Y:UPPer
CALCulate:STATistics:APD[:STATe]
This command switches on or off the measurement of amplitude distribution (APD). On
activating this function, the CCDF measurement is switched off.
Parameter
ON | OFF
Example
CALC:STAT:APD ON
Switches on the APD measurement.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A
CALCulate:STATistics:CCDF[:STATe]
This command switches on or off the measurement of the complementary cumulative
distribution function (CCDF). On activating this function, the APD measurement is switched off.
Parameter
ON | OFF
Example
CALC:STAT:CCDF ON
Switches on the CCDF measurement.