Rohde & Schwarz R&S FSL3 - Page 979

SENSe Subsystem R&S FSL
1300.2519.12 6.220 E-11
SENSe:POWer Subsystem
This subsystem controls the setting of the instruments channel and adjacent channel power
measurements.
Commands of the SENSe:POWer Subsystem
– [SENSe<1|2>:]POWer:ACHannel:ACPairs
– [SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth[:CHANnel]
– [SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth:ACHannel
– [SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth:ALTernate<1...11>
– [SENSe<1|2>:]POWer:ACHannel:MODE
– [SENSe<1|2>:]POWer:ACHannel:PRESet
– [SENSe<1|2>:]POWer:ACHannel:PRESet:RLEVel
– [SENSe<1|2>:]POWer:ACHannel:REFerence:AUTO
– [SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:AUTO
– [SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:MANual
– [SENSe<1|2>:]POWer:ACHannel:SPACing[:ACHannel]
– [SENSe<1|2>:]POWer:ACHannel:SPACing:ALTernate<1...11>
– [SENSe<1|2>:]POWer:ACHannel:SPACing:CHANnel
– [SENSe<1|2>:]POWer:ACHannel:TXCHannel:COUNt
– [SENSe<1|2>:]POWer:BANDwidth|BWIDth
– [SENSe<1|2>:]POWer:HSPeed
– [SENSe<1|2>:]POWer:TRACe
[SENSe<1|2>:]POWer:ACHannel:ACPairs
This command sets the number of adjacent channels (upper and lower channel in pairs).The
figure 0 stands for pure channel power measurement.
The numeric suffixes <1|2> are not relevant.
Parameter
1 to 12
Example
POW:ACH:ACP 3
Sets the number of adjacent channels to 3, i.e. the adjacent channel and alternate adjacent
channels 1 and 2 are switched on.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
A–F