SKF Microlog GX Series - Orbit View Options; A Raw (Unfiltered) Orbit Display

The Analyzer Module
How to Measure Shaft Orbit
Figure 4 - 20.
A Raw (Unfiltered) Orbit Display.
• Use cursor functions to analyze the measurement.
Average, Stop, Start, and Save function button options operate as previously described
in the Using the Default Measurement Setup section. Reference this previous section
for details.
Orbit View Options
View - Use the View function button to determine how to view the displayed orbit
measurement results.
View options for orbit measurements include:
Orbit (raw)
Orbit 1X
Orbit 2X
Orbit 3X
Time for CH 1, 2
Time 1X
Time 2X
Time 3X
Time 4X
Time for CH 1
Time for CH 2
4 - 30 SKF Microlog - GX Series
User Manual