SKF Microlog GX Series - Microlog System Connections; Communication Set up; Connectors on Top of the Microlog GX

Introduction to the SKF GX Series Microlog
Microlog System Connections
Microlog System Connections
WARNING! Refer to Appendix D of this manual for important restrictions when
using the CMXA 75-SL-Z2 Microlog in a Zone 2 restricted area.
Communication Set Up
Figure 1 - 10.
Connectors on Top of the Microlog GX.
 @ptitude Analyst ROUTE upload / download operations for GX
Series Microlog utilize USB communications.
To connect your Microlog to the host computer using USB connector:
• Connect the supplied USB / power splitter cable between the Microlog’s USB
Device connector and your host computer’s USB port connector.
• On the host computer, enable ActiveSync for USB connection. Do not set up a
partnership. When connection between the Microlog and ActiveSync is established,
ActiveSync displays “Connected.”
 ActiveSync communication with the GX requires specific drivers to
be installed on the host PC. Refer to the Microsoft

ActiveSync
Communications section, later in this chapter.
On the Microlog, the current screen automatically displays a communication dialog
when the communication link is established.
• Proceed with data transfer operations using SKF @ptitude Analyst software
Transfer menu options.
 The communication dialog remains open until the host-computer
link has been terminated
1 - 22 SKF Microlog - GX Series
User Manual