SKF Microlog GX Series - Manual Process Measurement Entry; To Manually Enter Process POINT Data

The ROUTE Module
How to Collect Process Measurements
Manual Process Measurement Entry
Process measurements can also be entered manually. For example, you can manually
type in numeric data for readings read from machinery or control panel gauges and
indicators.
To manually enter process POINT data:
• Use the left, right, up, and down arrow buttons to select the desired process
measurement POINT from the ROUTE list, and press an Enter button. The process
measurement data screen displays.
• Press the Manual function button or start typing on the numeric keypad. The
manual entry screen displays, and any data automatically collected prior to pressing
the Manual function button is disregarded.
• Use the numeric keypad to enter the appropriate reading into the text entry field. If
you make a mistake, use the Clear or Bksp (backspace) buttons to erase entered
text.
• After correctly entering the measurement’s reading, press an Enter button. The
entered value displays on the bar indicator. A new function button becomes
available; Edit, and the measurement’s alarm setpoints display as arrows.
 If the Configuration screen’s Auto Advance setting is set to On,
pressing Enter stores the measurement. To enter notes, use the
Notes function button on the ROUTE Hierarchy screen.
Function Buttons
Manual data entry display function buttons include:
Backspace – Deletes the entry to the left of the cursor in the text entry field, enabling
you to quickly edit the entry.
Clear – Erases all text in the numeric text entry field.
Notes – Accesses the Notes screen, allowing you to store coded notes for the POINT.
Back – Exits to the ROUTE mode’s ROUTE list screen without saving the measurement’s
data.
• Press an Enter button again to store the measurement data and continue collecting
data for your ROUTE.
SKF Microlog - GX Series 3 - 21
User Manual