SKF Microlog GX Series - How to Set Up a Conveyor Idler Survey

Idler Sound Monitor Module
How to Set Up a Conveyor Idler Survey
 At higher volumes (e.g., greater than 6 or 7), you may experience
a distorted / clipped signal. If this occurs, lower the volume to
reduce distortion.
How to Set Up a Conveyor Idler Survey
Overview
This section describes the Idler Sound Monitor module’s Setup mode options, which
define conveyor specifics and Idler Sound Monitor measurements.
To set up a conveyor belt idler survey:
• From the main screen, use arrow keys to highlight the Idler Monitor option, and
press an Enter button. The Idler Monitor menu displays.
Figure 11 - 12.
The Idler Sound Monitor Main Menu.
Function Buttons
Function buttons at the bottom of the screen include:
Help – Displays the Microlog’s context sensitive help screen.
Setup – Displays the measurement setup screen for the highlighted measurement type
(i.e., Recall or New).
Start – Take Idler Sound Monitor data using the currently highlighted icon’s settings.
Back – Returns you the Microlog’s Main Menu screen.
SKF Microlog - GX Series 11 - 11
User Manual