SKF Microlog GX Series - An Example Nyquist Plot with Three Traces Displayed

Run Up / Coast Down Module
Displaying Acquired Data
Nyquist Plot Display
• After setting Nyquist Setup options, press the Display function button to display
the Nyquist plot.
 The larger the acquired data .wav file, the longer the processing
time required.
Figure 7 - 9.
An Example Nyquist Plot with Three Traces Displayed.
active trace
cursor position: magnitude phase speed
On the displayed Nyquist plot:
 Left and right arrow buttons move the cursor.
 Shift (zero / up arrow) up and down arrow buttons sequence
through displayed traces.
 Tip – With a Nyquist plot displayed, use the “shift function” button
(0 / up arrow) to display Table and Bode function buttons that
allow instant display of Table and Bode displays.
7 - 12 SKF Microlog - GX Series
User Manual