SKF Microlog GX Series User Manual

Using the Headphones and Strobe Light
How to Use the Strobe Light with the GX
 At higher volumes (e.g., greater than 6 or 7), you may experience
a distorted / clipped signal. If this occurs, lower the volume to
reduce distortion.
How to Use the Strobe Light with the GX
WARNING! Not certified for use in hazardous locations.
Connecting the Strobe Light to the GX Series Microlog
Strobe light use requires accessory cables CMAC 5404 (input cable) and CMAC 5406
(output cable).
Figure C - 2.
Strobe Light Connected to GX Series Microlog.
To connect the strobe light to the Microlog:
• Connect the input cable to the USB Host / CH 4 / Headphone connector on the
Microlog.
• Connect the input cable’s jack plug into the
 socket of the strobe light.
• Connect the output cable into the USB DEV / TRIG / POWER connector on the
Microlog.
• Connect the output cable’s jack plug into the
 socket of the strobe light.
C - 2 SKF Microlog - GX Series
User Manual

SKF Microlog GX Series Specifications

General

Brand	SKF
Model	Microlog GX Series
Category	Measuring Instruments
Language	English