SKF Microlog GX Series - Uninstalling Modules

Introduction to the SKF GX Series Microlog
Module Management
Figure 1 - 4.
The Module Manager Screen.
• Use the up / down arrow keys to highlight the module whose icon you wish to hid
e
or show and press the second function button to either Hide or Show its icon.
 If you wish to show or hide multiple modules simultaneously,
highlight each module in turn and press Select. A check box
a
ppears next to each selected module. If you select multipl
e
modules and some are hidden while others are shown, the Show
/ Hide button reflects the status of t he highlighted module.
When it is pressed, modules that already reflect that status will
not be affected.
• Press the Back function button when you have finished hiding or showing modules
to exit the Module Manager.
Uninstalling Modules
The Uninstall function button on the Module Manager screen allows you to completely
remove highlighted / selected modules from the Microlog’s internal memory. This can
be useful if memory is low and you do not intend to use the module. Refer to the
instructions for hiding module icons, above, and select the Uninstall function button
rather than Hide.
 If you later decide to purchase a module you have uninstalled, it
may be reinstalled. Installing modules is documented in the
Module Manager and Firmware Installation Procedure document
on the Product CD.
SKF Microlog - GX Series 1 - 11
User Manual