Machinery Balancing Module
How to Perform a Single-Plane Procedure
Figure 5 - 12.
The New Trial Run Message.
• Press the Add function button.
The Trial Weight screen displays, allowing you to specify a different trial weight, angle,
or radius.
• Stop the machine and remove the old trial weight, and on the Trial Weight screen
enter the new trial weight, angle, or radius. Then start the machine and press OK
(or an Enter / Fire button) to proceed with a new trial run.
You may repeat the above procedure until you determine the trial weight, angle, or
radius you wish to use.
5 - 18 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
