The ROUTE Module
Viewing Dynamic Measurement Data
Figure 3 - 5.
ROUTE Status Display.
number of POINTs collected vs. total number of POINTs
indicates data collected for POINT – POINT in danger alarm
indicates data collected for POINT – POINT not in alarm
data not collected for POINT
Indicates data collected for POINT – POINT in alert alarm
• Repeatedly press an Enter button to collect subsequent POINTs in your ROUTE,
until the ROUTE is complete. The Last POINT of ROUTE message displays.
When disconnecting the sensor connector from the CH
connectors, ensure the red dots are aligned, grasp the sensor
near the sensor tip and pull gently (do not twist).
• At the “Last point of route…” message, press an Enter button to return to the
ROUTE mode hierarchy list screen. Press the Back function button to return to the
Route Mgr where you can initiate data collection for the next ROUTE.
Viewing Dynamic Measurement Data
Viewing Spectral Data
You may perform a preliminary field analysis on collected ROUTE data. A movable
cursor, controlled by left and right arrow keys, is provided to give you an accurate value
of both amplitude and frequency of individual spectral components on the Microlog’s
display.
3 - 10 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
