SKF Microlog GX Series - Add a Correction Weight to Plane a

Machinery Balancing Module
How to Perform a 1-2 Plane with Prognosis Procedure
If you press the 2-Plane function button, the dynamic 2 plane balancing procedure
resumes. Reference the previous How to Perform a Dynamic 2 Plane Procedure
section for instructions on how to complete the 2-plane procedure.
If you press the 1-Plane function button, in following 2 plane Correction Run screens,
all Plane B / CH2 fields are marked as N/A (not applicable).
Add a Correction Weight to Plane A
Figure 5 - 37.
Example of a 2-Plane Correction Weight Screen When You
Select to Proceed with a 1-Plane Prognosis.
Now the Correction Weight screen displays the permanent Correction weight, Angle,
and Radius balance solutions for Plane A at the top of the screen (Plane B settings are
marked N/A), and correction weight options at the bottom.
• Stop the machine, remove the temporary trial weights (if appropriate), and securely
attach the permanent correction weights at the precise angles and radii specified.
The Split Weight, Add/Remove, Correction, and Combine All fields – and the Actual
function button all operate as described in the previous How to Perform a Single-
Plane Procedure section.
 In all Correction Weight fields, use the up / down / right / left
arrow buttons to move between fields.
5 - 44 SKF Microlog - GX Series
User Manual