SKF Microlog GX Series - Enter Run-Out Range Value; Indicator Position

Spindle Test Module
Spindle Tests Overview
• Place the indicator in the bottom and outer position of the taper, approximately 1/4
from the ends.
Figure 10 – 15.
Indicator Position.
• Slowly rotate the shaft manually and read the total range value. Key in the result.
Figure 10 – 16.
Enter Run-Out Range Value.
• HSK tapers: after completing the radial measuring, follow up with an axial measure
of contact face and evaluate against the acceptance standard.
10 - 12 SKF Microlog - GX Series
User Manual