SKF Microlog GX Series - Imbalance Test Setup Screens; Preset Vibration Measurements

Spindle Test Module
Spindle Tests Overview
• Re-start the spindle and increase the speed to approximately 80% of maximum
speed (or typical operating speed). Be sure to avoid any resonance domains.
• In Imbalance test setup screens, enter spindle specific operating data.
Figure 10 – 7.
Imbalance Test Setup Screens.
• Use the imbalance test’s pre-set vibration measurement to determine vibration
amplitudes at test speed (1X RPM).
Figure 10 – 8.
Preset Vibration Measurements.
• If the imbalance value exceeds limits, proceed with balancing using the Microlog’s
Balancing module.
SKF Microlog - GX Series 10 - 7
User Manual