Introduction to the SKF GX Series Microlog
Microlog System Connections
If the instrument is configured to take ICP measurements and no
ICP sensor is attached, and error message appears on the screen.
In the event that the Enable ICP setting has not been configured in @ptitude Analyst
(for example, if a ROUTE was downloaded from an older version of Machine Analyst that
did not support this setting), you can set the Route ICP setting to Never.
When Route ICP is set to Never, a reminder prompt will display when you attempt data
collection for the first POINT in a ROUTE. If you press OK, the prompt will appear at the
beginning of each POINT. If you select OK to All, the prompt will not appear again until
another ROUTE is selected from the Route Manager.
External input signals can be taken from “buffered” outputs like
those on permanently mounted rack systems, process signals, or
from a signal generator.
Connector Details
Figure 1 - 12.
Microlog Connector Detail.
Mating Connector Details
• CH 1/CH2: Fischer: Part No. DPBE103A056-130
• USB DEV/Power/Trigger Fischer: Part No. DPBE103A057-130
• USB HOST/CH 4: Fischer: Part No. DPBE102A056-230
1 - 24 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
