How to Set Up Your GX Series Microlog
System Settings
Module ICP – Sensor Setting, Off, or Always On. (Not applicable to the ROUTE
module.) For measurement purposes, always set to Sensor Setting, which uses each
module’s pre-selected sensor ICP setting (as defined in the Sensor Settings module).
The Off and Always On settings are used for troubleshooting sensor problems. Off
turns sensor ICP off for all modules and Always On turns sensor ICP on for all modules,
regardless of each module’s pre-defined sensor ICP setting.
Date Format – Both European date (Day/Month/Year) and American date
(Month/Day/Year) conventions are available. Select the appropriate format:
DD/MM/YYYY; MM/DD/YYYY; YYYY/MM/DD
Time Zone – For use with Microsoft
ActiveSync operations. Select your time zone
from the drop down list. When ActiveSync synchronizes data between the Microlog and
PC, it synchronizes the date / time on the Microlog to the PC’s date / time. To prevent
the date / time being set incorrectly, the Microlog’s Time Zone setting should match
that of the PC.
Date/Time – Set the current date and time from the appropriate areas.
• Use the right and left arrow buttons to scroll between fields.
• Use the up and down arrow buttons or the numeric keypad to adjust the setting in
each field.
• Press an Enter button to accept your Date/Time changes.
Memory – Performs an operation on the active memory selected in the Route Memory
option. Options are:
-select cmd- – A placeholder: leave this option selected if you do not wish to
perform any Memory commands at this time.
Delete all ROUTEs – Clears all ROUTEs from the Microlog’s ROUTE hierarchy
list. This option preserves your system preferences, but deletes ROUTE
measurements and data (and non-ROUTE measurements and data if you are
in Legacy Nonroute mode).
Initialize – Formats the active memory, and deletes all ROUTEs, ROUTE
POINTs, and Analyzer POINTs (and non-ROUTE measurements and data if you
are in Legacy Nonroute mode) stored within the GX Series Microlog. This
process erases all stored data, but preserves the system settings and
parameters and also refreshes the active memory if the Microlog is
experiencing memory related problems.
Route Font – Big or Small.
Small - the ROUTE hierarchy is displayed in a smaller font.
Big - the ROUTE hierarchy is displayed in a larger font.
SKF Microlog - GX Series 2 - 5
User Manual
To Next Page
Loading...
