The ROUTE Module
How to Review Collected Data
How to Review Multi-Measurement Data
Some types of POINTs automatically collect multiple measurements when data is
collected for the POINT. These include:
Two channel POINTs, which collect data on CH1 an CH2 simultaneously.
Triax POINTs, which simultaneously collect three measurements for the
sensor location (one for each axis monitored by the Triax accelerometer
sensor).
FFT & Time POINTs, which automatically store both an FFT spectrum and
time waveform for the measurement.
MPA POINTs, which relate a group of POINTs to one sensor location. The
Microlog allows you to review data for each MPA POINT in an MPA group.
When reviewing these types of data, you are able to cycle through each related
measurement in the Review screen.
To review multi-measurement data:
• In the ROUTE hierarchy, use the left, right, up, and down arrows to highlight the
POINT you would like to review and press the Review function button. The first
measurement displays.
Figure 3 - 17.
An MPA Spectral Display Review Screen.
• Press an Enter button or the Next function button to view display screens for the
remaining measurements, or
• Press the Previous function button to go back to the prior measurement.
• Press the Delete function button to delete the measurement. In the case of MPA
groups, delete deletes the measurements for all POINTs in the group.
SKF Microlog - GX Series 3 - 31
User Manual
To Next Page
Loading...
