SKF Microlog GX Series - Non ROUTE Mode

Non ROUTE
Non ROUTE Mode Operations
Figure A - 1.
Non ROUTE Mode.
user defined measurements
pre-set measurements
Function buttons
Function and Enter button operations for the Non ROUTE mode include:
Enter –Initiates data collection for the highlighted pre-defined measurement; or from
User mode, initiates the user-defined measurement.
Review – Opens the Review Data screen where you can review past measurement
data.
User – Initiates User mode, allowing you to set up a new Non ROUTE measurement for
immediate data collection.
 Reference the User Setup section later in this chapter for more
information.
Back – Press the Back button to exit the Nonroute mode and return to the main
screen.
Shifted Function buttons include:
Help – Press the Help function button to quickly view on-line help for Microlog data
collection.
Configure – Initiates Configuration mode, allowing you to change global data collection
settings. Note that changes to these settings apply to all Microlog measurements,
including both ROUTE and Non ROUTE measurements.
A - 2 SKF Microlog - GX Series
User Manual