Conformance Check Module
How to Set Up or Customize Conformance Test Templates
“Measurement - dB Reference” Sub-tab
Figure 9 - 8.
Measurement – dB Reference Tab.
Enable dB – Enable if you are using decibels to measure vibration. When enabled, the
Baseband and Enveloper areas become editable. Enter your 0dB reference value,
measurement units, and detection type for Acceleration, Velocity, and Displacement
measurements.
“Measurement - Measurement Control” Sub-tab
Figure 9 - 9.
Measurement – Measurement Control Tab.
Operator ID required – Enable if entering a unique operator ID is required before
taking measurements. This allows you to associate a set of measurement results with a
specific operator.
Results to CSV – Enable to save a results report in CSV format along with the default
report (in CCR format). The CSV report can be viewed using Excel after uploading to the
PC.
9 - 8 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
