The ROUTE Module
How to Collect ROUTE Measurements
Skip M/C – When the hierarchy pointer is on a Machine, or a Machine’s first POINT,
press the Skip M/C function button to skip that Machine’s POINTs and move to the next.
When you press Skip M/C, before skipping to the next machine, the Microlog displays
the Notes screen, allowing you to select a coded note to indicate the reason for skipping
the machine (i.e., Machine Not Operating).
A Note about the Auto Advance Setting
In the Configuration screen, the Auto Advance setting determines how resulting
spectra display during ROUTE data collection. Options are:
On – Quickly and automatically advance through ROUTE data collection,
displaying each spectral measurement result for a designated Dither Time.
Off – Manually advance through ROUTE data collection, displaying each
spectral measurement result until the fire key is pressed to stop the
measurement and Continue is pressed to move to the next POINT in the
hierarchy.
Dither Time – Time, in seconds, for which spectral results are to be displayed before
Auto Advance moves to the next POINT in the hierarchy.
How to Begin Route Data Collection
To begin ROUTE data collection:
• From the main screen, select the ROUTE mode option. The Route Mgr screen
displays a list of all ROUTEs stored on the Microlog.
• With the ROUTE list displayed, use the up/down arrows to highlight the name of the
ROUTE you wish to make active, then use the Enter or right arrow button to select
the highlighted ROUTE. A progress dialog appears as the Microlog loads the
ROUTE into memory, and the specified ROUTE’s hierarchy displays in the ROUTE
list.
SKF Microlog - GX Series 3 - 7
User Manual
To Next Page
Loading...
