Introduction to the SKF GX Series Microlog
What is the GX Series Microlog System?
Microlog Application Modules
The GX Series Microlog utilizes application modules installed on the unit to perform
various machinery monitoring needs. Each module performs a specific vibration
monitoring task. Current modules include:
• Setup • Sensor Setup
• Route • Analyzer
• Balancing • Data Recorder
• Run Up / Coast Down • Frequency Response Function
• Check to Conformance • Spindle Test
• Idler Sound Monitor
All of the above modules are preinstalled at the SKF factory on all Microlog models.
However, not all modules are pre-licensed on all Microlog models. A module must be
licensed for it to be active (i.e., unlicensed modules are inactive, and display dimmed
module icons). The various GX Series Microlog models (GX-R, -M, and –F) have specific
modules pre-licensed at the SKF factory. However, if you require a module that is not
pre-licensed for any Microlog model, you may purchase the license and activate the
module at your site. This allows you to customize your GX Series Microlog for your
specific needs.
ROUTE Based Microlog Models
The GX-R, -M, and -F series Microlog systems are pre-licensed for ROUTE based data
collection purposes. That is, they facilitate the collection and review of ROUTE
measurements downloaded from SKF @ptitude Analyst host software.
The GX-R Microlog
The GX-R model is an entry level ROUTE based data collector that provides basic data
collection and reviewing functionality, but does not provide off-ROUTE analysis
capabilities. Also, the GX R is limited to one channel data collection. This Microlog
model has the following modules pre-licensed from the SKF factory:
• Setup
• Route
The GX-M Microlog
The GX-M model is a mid to high-level ROUTE based data collector / analyzer that has
the following modules pre-licensed from the SKF factory:
• Setup
• Sensor Setup
• Route
• Analyzer
• Balancing
1 - 6 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
