SKF Microlog GX Series - Clamp Force Test Overview; Run-Out Test Results; Perform a Clamp Force Test

Spindle Test Module
Spindle Tests Overview
Figure 10 – 17.
Run-Out Test Results.
Clamp Force test overview
Figure 10 – 18.
Perform a Clamp Force Test.
To perform a clamp force test:
• Visually inspect shaft taper and fingers for wear, and determine if fingers are
missing and/or lack lubrication.
• Power the Microlog on and select the Spindle module’s Clamp Force test.
• Enter the tool holder type, ISO or HSK, and size.
SKF Microlog - GX Series 10 - 13
User Manual