SKF Microlog GX Series - A Triax Spectrum Display Screen; Viewing Multi-Channel Data

The ROUTE Module
Viewing Multi-Channel Data
Viewing Multi-Channel Data
@ptitude Analyst provides the facility to create multi-channel POINTs. When collecting
data for these POINT types, multiple measurements are collected simultaneously and
displayed on the Spectrum Display screen. These POINT types include:
Two - channel – This POINT type requires two sensors (one on CH1 and the
second on CH2). Two - channel POINTs show a spectral display for each
channel. Note – two channel “FFT and time” measurements display four
traces; CH1 FFT, CH1 time, CH2 FFT, and CH2 time.
Three - channel – This POINT type is collected with a Triax Accelerometer
Sensor, which simultaneously collects three measurements for the sensor
location (one for each axis monitored by the triax accelerometer sensor). Triax
POINTs show three spectra, one for each axis.
 Although Triax POINTs are referred to as “three-channel,” data is
only collected on CH1. The measurement results, however,
display as multi-channel.
 Refer to the documentation that accompanied your Triax
Accelerometer Sensor for information on mounting and using the
Triax sensor.
Data collection for these POINT types results in multiple spectral displays.
Figure 3 - 10.
A Triax Spectrum Display Screen.
SKF Microlog - GX Series 3 - 17
User Manual