How to Set Up Your GX Series Microlog
Sensor Setup
Figure 2 - 5.
An Add Sensor Screen.
Function Buttons
Help – Press the Help function button to quickly view on-line context sensitive help.
OK – Press the OK function button to save the new sensor’s configuration.
Cancel – Press the Cancel function but to return to the Sensor Setup screen without
saving any updated settings.
Use the right arrow key to display the highlighted field’s options.
Press an Enter button, the left arrow key, or the OK button to
accept the current selection in all fields / lists.
The following sensor parameters are configured from the Add Sensor screen:
Sensor – Enter the sensor’s unique name (that will identify the sensor in the sensor
list).
Sensor Family – Vibration or Process. Specify whether the sensor measures
Vibration data or plant Process data (i.e., temperature, pressure, etc.).
Sensor Units – From the drop down list, select the measurement units to use for the
sensor’s measurements. This determines the type of measurement the sensor takes.
Displayed measurement units are determined by the Sensor Family setting.
Sensor Sensitivity – Use the numeric keypad to enter the sensor’s sensitivity.
ICP Power – On or Off. Select to turn ICP power Off or On for the sensor.
To view an existing sensor configuration:
• From the Sensor Setup screen, use the up and down arrow keys to highlight the
sensor whose configuration you wish to view and then press the View function
button. The View Sensor screen displays the sensor’s configuration.
2 - 12 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
