The ROUTE Module
How to Collect Process Measurements
Figure 3 - 12.
A Process Measurement Data Screen.
Function Buttons
Process display function buttons include:
Manual – Accesses the measurement’s manual entry screen. Press this function button
if you wish to perform manual data entry for the POINT. Any data automatically
collected prior to pressing the Manual function button is disregarded.
Edit – After manual data entry, press Edit to change the previous entry.
Retake – Press to retake measurement.
Notes – Press the Note function button to access the Microlog’s Notes screen, where
you may view or add coded notes for the current POINT.
For more information, reference the Coded Notes section later in
this chapter.
Back – Exits to the ROUTE mode’s ROUTE list screen without saving the measurement’s
data.
• Press an Enter button to store data and return to the Route mode ROUTE list.
3 - 20 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
Need help?
General
