Introduction to the SKF GX Series Microlog
SD Memory Card Operation
Figure 1 – 15.
Hardware Installation.
• Microsoft ActiveSync or Mobile Device Centre launches and asks to Set Up a
Partnership. Select No and click Next. ActiveSync displays its Connected dialog.
The required drivers are now installed and the Microlog is able to communicate
with the host PC.
SD Memory Card Operation
SD and SDHC cards (up to 16 GB) may be inserted when the instrument is powered on
or off. Memory cards must be properly formatted prior to use.
IMPORTANT – The SD card should not be disconnected in hazardous areas, it must
be connected / disconnected in safe areas only.
The Microlog GX is only certified for use with the following SD card:
• Sandisk: Secure Digital Card SDSDx-yyy
SD Card Memory Advantages
SD cards provide greater memory flexibility for ROUTE storage than the internal
memory. SD cards are flexible and mobile, which is efficient in plants with more than
one Microlog. Independent ROUTEs can also be stored on different SD cards.
For more information on configuring ROUTE Memory settings,
reference the System Settings section in Chapter 2, How to Set
Up Your GX Series Microlog.
SKF Microlog - GX Series 1 - 27
User Manual
To Next Page
Loading...
